UHU Wood Adhesive 27ml UHU37585

Fast-drying (4 minutes), moisture-resistant adhesive for bonding and laminating hard, soft, and exotic woods. Ideal for interior applications like furniture and joints. Apply to clean surfaces, assemble within 10 minutes, and clamp for 4-15 minutes. Remove wet residue with water and store in a cool, dry place.

High quality, fast (4-minute drying time), moisture resistant (EN 204 D2) white wood adhesive for internal use. Dries transparent. Stronger than wood. For bonding and laminating of practically all hard, soft and exotic types of wood.

FEATURES:

• Very fast (4 minutes)
• Stronger than wood
• Transparent when dry
• Ideal for interior applications (EN 204 D2)
• Paintable
• Solvent-free

APPLICATION

Suitable for:

• For moisture resistant and quick joining and laminating of practically all hard, soft and exotic types of wood. Suitable for well-fitting, non-load bearing wooden structures using, for example, finger joints, dovetail joints, mortise and tenon joints, dowels and springs.
• Suitable for indoor applications such as doors and furniture in, for example, living rooms and offices. For surface bonding wood, hard and softboard, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic sheet (HPL, Formica, Duropal, Resopal) on a wooden surface.
• EN 204 D2: Interior spaces in which increased relative humidity occurs occasionally and for a short time, whereby the level of wood humidity remains below 18%.

HANDLING

Before use:

Working conditions

The ambient temperature, the adhesive and the materials to be bonded should be no less than +5 C. Relative humidity of up to 65%. Level of wood humidity between 8% and 12%.

Surface requirements

The surfaces to be bonded need to be clean, dry and free of dust. Ensure a well-fitting joint.

Preliminary surface treatment

Degrease oily types of wood with thinner.

Tools

Fine-toothed glue spreader (1 mm), brush or roller, clamp or press.

During use:

Directions for use

Apply the adhesive with a brush or some other tool in an even and thin layer on one or both parts. Let penetrate for a few minutes, assemble the parts within 10 minutes and clamp or press for 4-15 minutes. The desired pressure is 2-5 kg/cm .

After use:

Stains/residue

Remove adhesive residues immediately with water. Dry adhesive residue can only be removed mechanically.

Storage conditions

Close container properly and store in a dry, cool and frost-freeplace.