UniLight 60mm Light Spreader Nozzle RING-CAP-60

New attachments for our afterburner rings for optimal light distribution. Translucent material with reflection particles from the lighting technology. High-quality extruded in the form of a Nozzle the attachments fit exactly on our individual rings.

Attachments for double rings 109 + 125 or 125 + 141 are designed as a 3D printed part.

The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.

The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded.Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED!