UniLight Dual Strobe Light Module, 24Wx3 – White STRB4-240×3-WE

DIY double strobe series as a replacement for flash tubesExtremely powerful strobe chips in a double-row design with numerous high-power chips. The design makes it ideal for use as a tube replacement in tail units or nose strips. The light may only be operated with short strobe pulses without further cooling.Reliable visibility over many hundreds of meters, on both sides of the model!Electric: 24W reference power with x3 technology, 12V only, 2.0A
Beam angle: ~ 2×120
Light intensity: ~ 3000 lumens WHITE
Dimension: 8x18x28mm
Weight: 4g (without cable)With 1m silicone connection cable, ready for connection for 12V/3S LipoThe reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.

The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded.Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED!