E_Brakes Controller from Electron

The perfect solution when only electric brakes are necessary.

Up to 12V/3A. 2 connection ports to connect 2 wheels.

Adjustable end points and 5 brake modes (Continuous orPulsed, ABS like effect).

DESIGNED WITH BRAKES IN MIND: We know that sometimes you dont need a full controller, and just need to control your Electric brakes. We have you covered, we have the Electron-Retracts E-Brake Controller.

SMALL SIZE, BIG POWER: Dont be put off by its small size. The Electron-Retracts E-Brake offers the same braking power as the rest of our controller range.

FULLY PROPORCIONAL: Control precisely how much power is applied to the brakes at any given time.

OPTIONAL PROGRAMMABLE ABS: Choose from between 5 different braking modes, either continuous braking or 4 different ABS settings.

EASY SETUP: Complete setup in seconds using the intuitive integrated button. Just solder on your battery connector of choice.

INSTRUCTIONS:

• Connect the servo lead to the brake output of the receiver.
• Connect the Red (+) and black leads to the battery. Recommended battery voltage 7,2V (2s Lipo, 5 NiCd-NiMh). A123 2s and 3s allowed. 3S Lipo not recommended on 6V brakes.
• Connect the brakes to the output connectors.

Adjustment:

• Power ON the TX and set the brake command to minimum. (Brake OFF position)-
• Power ON the receiver while keeping the button on the controller pressed. Once the blue led lits, release the button.
• The LED light will blink in a sequence of 1 blink. Check that your TX is set at the position of” Brake Off” and click on the button.The controller will store the received command as OFF command.
• The LED light will blink in a 2 blink sequence. Set the transmitter to the BRAKE MAXIMUM position. Click on the button to store the command.

Now the brake force will be proportional from zero to maximum.

ADJUSTING the “ABS”:

The unit allow to modulate the brake force in 5 different steps to allow the wheel to rotate while appliying maximum brake force without creating flats on the tyre. Adjustment is simple: Just press the button to loop trough the 5 modes, from continuous brake to maximum pulse, checking the effect on the wheel until arriving to the desired pulse ratio.

Limiting the brake force:

If you want to limit the maximum brake force, you can do by reducing the ATV on the TX after doing the travel adjustment.

Diferential braking:

Each controller usually control the two main wheels, but If you need to control the brake force separately on each wheel, like is done in the full size warbirds to steer, then you need two controllers, one in each wheel, and to do the appropiate mix on the transmitter.