PowerBox Sensor Switch 7.4v 6311 with JR ConnectorsReplaced by the V3 6330

For those modellers that want to use a high voltage 2s system but want a switch that will work at those voltages safely and with a regulated 7.4 volt supply givingconsistent servo speed.

This fantastic Powerbox Switch is not just a switch.

It combines a pair of independent regulated 5 amp receiver outputs all mounted in a neat twin switch housing with battery leds.

Power handling up to 5.0 Amps (according to heatsink)

Power supply: 2 x 2-cell LiPo battery, 7.4 Volt

2 x 5-cell NiCd or NiMH batteries

2 x 2-cell LiFePo battery (A123)

Two independent linear voltage regulators, supplying 5.90 Volts Two independent electronic switches Two volt controller ( in 4 steps ) for each battery NEW Two Low voltage memory for both batteries NEW SET button for On / Off switching protection LED indicators for both power circuits Operating voltage range 4.0 to 9.0 Volts Temperature range -10 to +75 C Voltage loss approx. 0.35 Volts Weight only 35 grammes incl. all cables

Please follow this link for the manual.http://www.powerbox-systems.com/shared/download/bedienungsanleitungen/PowerBox_Sensor_englisch_f.pdf

6311