UniLight 2x4W Flat Light Double in RED FLAT-040-2xRT

Two flat recessed light for direct mounting behind existing glazing on thin wings or tail units. Optimal light output on the top and bottom side. The waste heat on the mounting level is dissipated on a special aluminium core PCB, which is why these lights only have a 7mm headroom. The scope of delivery contains two optionally usable, self-adhesive heatsinks and mounting screws. For longer operation time, the heatsinks can be placed underneath or above, depending on the space available. The lights are wired ready for operation and can be mounted in different distances with accessories provided.

Electricity: 2x4W reference power, 8(12)V, 0.35A
Beam angle: ~160
Light intensity: ~2×50 Lumen RED
Light intensity: ~2×75 Lumen GREEN
Light intensity: ~2×100 Lumen WHITE
Dimension flat light : 16x32x7mm
Dimension additional heatsink: 15x15x6mm, 2 items
Weight: 10g (without cable)

Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed, 2 heatsinks, mounting screws and spacer

The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.

The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded.Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED!